Magnetic pumps offer several distinct advantages that make them a preferred choice in many industrial applications. First, unlike traditional pumps, magnetic pumps do not require a shaft to pass through the pump housing. Instead, they use a magnetic coupling system, where the motor drives an external magnet, which in turn rotates the internal rotor through an air gap and a thin-walled isolation sleeve. This design completely eliminates the need for a mechanical seal, thereby preventing leakage and ensuring a fully sealed operation. Second, these pumps are equipped with overload protection mechanisms, which help prevent damage caused by excessive load or power fluctuations. Third, while the magnetic materials and magnetic circuit design must meet higher standards, the rest of the pump’s components generally have more conventional technical requirements. Fourth, magnetic pumps are known for their low maintenance needs, as they have fewer moving parts and less wear on critical components.
However, there are also some disadvantages to consider. One major drawback is that magnetic pumps typically have lower efficiency compared to standard centrifugal pumps. Additionally, they require stricter manufacturing and material selection to prevent single-sided leakage. If the isolation sleeve is not properly made or the materials are unsuitable, it may not withstand the friction between the inner and outer magnets, leading to wear and potential failure. Moreover, due to limitations in magnetic materials and drive systems, magnetic pumps are usually suitable only for media with temperatures below 100°C and pressures under 1.6 MPa. The isolation sleeves also tend to have poor wear resistance, making them unsuitable for transporting fluids containing solid particles. Lastly, the magnetic coupling requires precise alignment; any misalignment can cause bearing damage and accelerated wear on the isolation sleeve.
In terms of operating requirements, magnetic pumps should be used within their designed parameters. Under normal conditions, they do not experience demagnetization over time. However, if the pump is overloaded, stalls, or operates above the allowable temperature for the magnets, demagnetization can occur. Therefore, it's essential to operate the pump correctly. Another key point is that magnetic pumps cannot run dry, as this may cause the sliding bearing and isolation sleeve to overheat and fail. They should also not be used with media containing ferromagnetic or hard impurities, as these can damage internal components. It's recommended that the pump does not operate below 30% of its rated flow.
While magnetic pumps don’t require frequent maintenance, regular checks are still necessary. Operators should monitor current, temperature, outlet pressure, and ensure there is no leakage. The pump’s stability, vibration, and noise levels should also be checked periodically. It is generally advised to perform inspections every two to three months, but more frequent checks should be conducted if any abnormalities are detected. This proactive approach helps ensure the pump runs efficiently and safely over its service life.
Solenoid Coil Hole Diameter 14mm
The category of solenoid coil which hole diameter is around 14mm. Possible applications are solenoid valves like Dust Collector Pulse Valve, refrigeration valve, Pneumatic Valve, hydraulic valve, LPG CNG valve, automobile valve, injector rail, home appliance Solenoid Valve, and so on.
14mm Hole Solenoid Coil, Solenoid Valve Coil DC24V, Solenoid Valve Coil AC220V, Solenoid Valve Coil AC110V
NINGBO BRANDO HARDWARE CO.,LTD , https://www.brandopneumatic.com