Latex paint is a common type of architectural coating products, generally composed of emulsions, pigments, fillers, additives and water. Emulsion is the most important raw material affecting the performance of latex paints, usually synthetic resin emulsions. Compared with other coatings, the production process of latex paints is relatively complicated. The latex paint production process mainly has the following major steps:
1. Put water on;
2. Distributing the microbicide;
3. Put into a film forming aid;
4. Putting thickener;
5. Putting a pigment dispersant;
6. Putting antifoaming agent and wetting agent;
7. Putting in pigment and filler;
8. Putting the emulsion;
9, pH adjuster;
10. Put in other additives;
11. Place a water and/or thickener solution.
Latex paint production process operation procedures:
The water is first placed in a high-speed mixer, and a microbicide, a film-forming aid, a thickener, a pigment dispersant, an antifoaming agent, and a wetting agent are sequentially added at a low speed. After mixing uniformly, the pigment and filler are slowly sieved into the vortex stirred by the impeller. Shortly after the addition of the pigment filler, the abrasive material gradually thickened. At this time, the distance between the impeller and the bottom of the paint mixing bucket should be adjusted to make the vortex into a shallow basin. After the addition of the pigment filling, the impeller speed is increased (the linear speed of the wheel edge is about 1640 m/min). In order to prevent the temperature from rising too much, it should be stopped to cool down, and the pigment and filler adhered to the barrel edge should be scraped off during parking. The fineness of the blade is measured at any time, and when the fineness is qualified, the dispersion is completed. After the dispersion is completed, the emulsion, the pH adjuster are gradually added at a low speed, and other additives are added, and then the viscosity is adjusted with water and/or a thickener solution, and the discharge is sieved.
Concerned about surprises
Label: latex paint production process
Previous: How to prevent the phenomenon of shrinkage during the ceramic making process? Next: Wood plastic door technology advantage
Using advanced hot-dip galvanized material , precision roll forming production process, polyurethane foam that free of hydrofluorocarbon inside door, light weight, high strength, appearance nice. The doors have advantages of tamper anti-theft , noise isolation thermal insulation and corrosion resistance;the doors are widely used in shops, garages, houses, supermarkets, warehouses and industrial plants,etc.
Depending on the characteristics of the buildings,we can choose interior, exterior and intermediate three different installation ways, doors stay in the upper part of door after rolling up , this could save garage space, and also could keep the garage clean and beautiful by prevent the mud, rain and snow ,etc going into the garage.
Galvanized Roller Shutter Door
Galvanized Roller Shutter Door,Standard Galvanized Roller Shutter Door,Automatic Galvanized Roller Shutter Door,Steel Roller Shutter Safe Door
Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hongfadoor.com